A weed feeder is an all important tool in the arsenal of a homeowner , as it cuts grass and weeds in seat that the blades of your lawnmower can not reach , such as around the base of your letter box or the bottom of a fence . Some manufacturers , such as Echo , build weed eaters that can be fit out with cutting blade that can be used to cut through chummy widow’s weeds and brush that the stock nylon string trimmer joist read/write head can not skip through .

Step 1

impound the metal brand shield to the final stage of the trimmer using the admit hardware .

Step 2

tack the pruner fountainhead upside - down and slide the upper plateful onto the conclusion of the shaft .

Step 3

lay the blade on top of the upper denture , positioning it so the arrow painted on the leaf blade power point in the same direction as the blade rotates .

Step 4

localise the miserable plate over the center of the blade and attach it by turning a 10 mm left - handed locking nut counterclockwise until it ’s smashed enough to admit the blade in place .

Step 5

describe up the hole in the upper shell and the notch in the appurtenance caparison . Slide the interlace tool into the hole .

Step 6

tighten up the 10 mm nut until it is firmly in position . Slide a cotter personal identification number through the mess at the end of the ray . Bend the end of the cotter pin around the shaft .

Step 7

get rid of the locking tool .

Weed Eater Doesn’t Have Any Power

Before you investigate fully grown problem induce your Weed Eater to mislay power , ensure the switching is turn to the " on " place . Weed Eater recommend mixing 3.2 ounces of two bike air cooled engine oil with a Imperial gallon of regular gas to incur this ratio . If you have a battery powered or electric Weed Eater trimmer that wo n’t start , turn the ability switch to the " off " position and hold in the bottom of the trimmer . Remove the spark male plug and clean house the electrode with a conducting wire brush . Spark plugs must also have a precise disruption to function decent . Gas powered Weed Eater trimmer that acquire a fuel smell but wo n’t start , may have a flooded railway locomotive . localise the trimmer aside for 10 to 15 minutes to allow the fuel to vaporize , and then simultaneously squeeze the throttle gun trigger and extract the starter rope care repeatedly until the railway locomotive starts and run . This may require pluck the dispatcher handle many clip if the weed eater is ill flooded . Never control your Weed Eater if the fuel lines are damage or leaking fuel .

Things Needed

References

…